Overview
A car trunk mat is a molded grid panel that lies on the floor of a trunk and lets dirt and water drop through it. It is molded as one part: a plate of round drain holes set on raised rings, a lattice of ribs between the rings, short feet on the underside, and tabs along the edges that lock to the next panel.
Grit and water fall through and sit under the panel, so the face a load rests on stays clear. Each ring carries the load on a wall around its own hole rather than on a flat sheet, and the ribs tie the rings together, so a car trunk mat spreads a load across the panel.
Two panels join on the tabs, so a floor wider than one tool is covered in rows.
Key Features & Benefits
- Drain holes on raised rings: water drops through, the ring takes the load
- Rib lattice: ties the rings together across the panel
- Interlocking tabs: two panels join along one edge without a fastener
- Feet under the grid: hold the panel off the floor and let water run under
- Border rim: a line to trim to the trunk outline
Because the grid is molded in one shot, this car trunk mat repeats its hole pitch and tab spacing from panel to panel.
Customization Options
- Panel size: rows and columns of holes
- Hole: diameter and ring height
- Rib: width, depth and pattern
- Tabs: square, hooked or a dove joint
- Feet: height and count
- Material: polypropylene or a rubber modified grade
- Color: black, gray or a matched shade
The panel outline can follow the trunk floor and stop short of the wheel arches, so the car trunk mat drops into the well without trimming on site.
Quality & Delivery
Tooling for a car trunk mat is cut in our own mold shop, and the first article is gauged against your 3D file, hole pitch and tab spacing included, before the run.
Mold faces are polished to the sheen your 3D file calls for, the gate is trimmed flush, and the panel comes off the tool flat so it lies on a floor with no rock. Lead time is quoted with the unit price and held to the date, and each batch is gauged before packing.
We mold every car trunk mat to your 3D file, so the grid, the feet and the tabs follow the model. Send the 3D file for a quotation with the tool cost and the unit price.
Related Capabilities
A soft mat without the grid sits beside this car trunk mat. Our silicone honeycomb mat is a pad for a counter, and the silicone drain pad takes water off a sink.
Where a part carries a load over a wide floor, the ribbed tray and the molded bumper use the same rib logic.
Molding runs in house on our mold making floor, with injection molding for the panel. Our automotive plastic parts page groups vehicle work, our capabilities page lists the cells and our works page shows past jobs.
